Soundcraft Delta 32 Mixer Console repair service noise gain – Global Sound

18 Comments / video / By

Global Sound –

How to fix a Soundcraft Delta 32 mixer with channels that cut out and have very noisy gain or trim controls
Video Rating: 4 / 5

Powered by Global Sound

18 thoughts on “Soundcraft Delta 32 Mixer Console repair service noise gain – Global Sound”

  1. fm711

    I have a Yamaha MX12/4 stereo mixer. Every other channel (odds numbers) do not work. I was wondering if there is a likely culprit. I am not sure what happened, but someone said that the problem may be related to overloading the insert. It is possible that I tried to use the channel one insert as the input for an acoustic guitar with effects and sent too much power through that channel? Where would I look for a common component that would cause the other channels to fail?

  5. robstorms

    I would say it is a problem with control settings but the fact that the bad channels are all 8 apart is fishy. Sorry I can’t offer any advise. i can’t think of a defect that would do that. Make sure it is not operator error. It usually is when I am the operator

  6. MoonGhostMusic

    I have Soundcraft Ghost 32/ problem with group 2 when I input channel 2/10/18/26
    i GET CHANNEL READING SIGNAL AND SIGNAL IS LIT ON GROUP 2 BUT NOT ON
    CONTROL ROOM LEFT AND RIGHT SO NO SIGNAL ON RECORDER ? CAN i FIX MYSELF ? NO TECH CLOSE TO ME..THANKS IN ADVANCE.

  7. rainbowsalads

    hi : )

    i noticed on each channel at the top by the pre amp pots there are additional toggle/flip type switches , i wonder what they are for?

  9. randallquan

    thanks for the good info. I’m thinking about pickup up a used (of course) 8 chan. SR w/ a group output LED ladder that doesn’t function. I’m currently using a Spirit M12 as a front end – any comments on comparing the SR with the M12 as far as sound?

  10. thebola82

    i only need the power supply.. what would be your price for it?? i dont know how much to offer i dont want to offend with an offer that may not be good..

  11. FreshMusicAustralia

    i’ve got a power supply for a CS3 … am trying to sell the whole desk so if I don’t or you make me an offer I can’t refuse ;D then maybe it’s yours! cheers

  13. thebola82

    i have a question.. do you knew where i can get a power supply for a dda cs3?? ive been looking everywhere but cant find anything

  15. nightfly1985

    I use DEK contact cleaner, it is a deagreaser and a silicone lubricat. The one I used is safe for most plastic, very inportant so that cheap pot’s don’t brake on you. Seen this when I used brake cleaner for though job’s but it works.

    Bob

  16. robstorms

    I use Caig DeOxit; the little tiny full strength bottle if I can get to the contacts directly, the spray if I can’t. It seems to work fine; other cheaper stuff( maybe even spit) might work as well. I think most of the battle is to get something wet on there to wash off the crud.

  17. WhoresOfBabylon

    Useful vid, I use a 24 track Delta at home, Just fixed a problem by just cleaning inside the affected area, but I`ll certainly bear your tips in mind if ( or rather when )I need to service it again

  18. vintagevibekeyboards

    Good troubleshooting tips, especially removing three modules to get more length on your multipin connector.

Comments are closed.